MSI MS-7310 Mode D'emploi page 18

Memclock Mode
This item allows yo u to select the memory frequency programming method. If select Auto, the
memory speed will be based on SPDs. If select Limit, the memory speed will not exceed the
specified value. If select Manual, the memory specified will be programmed regardless of SPD
Adjust DDR Voltage (V)
Adjusting the DDR voltage
cause a stability issue, so changing the DDR voltage for long-term purpose is NOT
recommended.
CK804(SB) to K 8(CPU) Freq Auto
When set to [Enabled], the HyperTra
automatically.
CK804(SB) to K 8(CPU) LinkWidth
This item allows you to select the Hype
Spread Spectrum Configurations
When the motherboard's clock gener
creates EMI (Electromagnetic Interference). The Spread Spectrum function reduces the EMI
generated by modulating the pulses so that the spikes of the pulses are reduced to flatter curv
If you do not have any EMI problem, leave the setting at Disabled for optimal system stability and
performance. But if you are plagued by EMI, set to Enabled for EMI reduction. Remember to
disable Spread Spectrum if you are overclocking because even a slight jitter can introduce a
temporary boost in clock speed which may just cause your overclocked processor to lock up.
Auto Disable PCI Clock
This item is used to auto di
(turn off) clocks from empty PCI slots to minimize the electromagnetic interference (EMI).
Load Optimized Defaults
You can load the default values pro
performance.
All manuals and user guides at all-guides.com
can increase the DDR speed. Any changes made to this setting may
nsport frequency will be selected by CPU capability
rTransport Link Width.
ator pulses, the extreme values (spikes) of the pulses
sable the PCI slots. When set to [Enabled], the system will remove
vided by the mainboard manufacturer for the stable
12
.
es.