Roland BA-330 Mode D'emploi page 17

Connections that allow the input jacks of
both units to be used
This arrangement lets you play in stereo, making maximum use of
the two BA-330s' mixer functions (with 12 inputs).
L
CH 1�6 �6 6
AUX IN
1.
Connect the devices to the BA-330 (L) and BA-330 (R).
2.
Connect the STEREO LINK OUT R jack on the BA-330 (L)
and the STEREO LINK IN jack on the BA-330 (R).
3.
Connect the STEREO LINK OUT L jack on the BA-330 (R)
and the STEREO LINK IN jack on the BA-330 (L).
4.
Turn on both BA-330 (L) and BA-330 (R).
5.
Adjust the volume levels on all devices.
6.
Adjust the BA-330 (L) and BA-330 (R) volume levels sepa-
rately using their [VOLUME] knobs.
Adjusting the volume and tone quality
Adjust the L and R volume levels separately using their MASTER
[VOLUME] knobs. You can adjust the EQUALIZER ([LOW]/[HIGH]
knobs) independently for the L and R sides. Basically, they should be
set to the same positions, but you can adjust each one as necessary
to suit the needs of a particular setup.
Using a stand
Using the BA-330's stand
When using the BA-330 on floors, or in other low-lying positions,
then setting up and using the arm stand can make it easier to hear
the sound from the speakers.
Using the arm stand
1.
Turn the BA-330 over and raise the arm stand.
R
CH 1�6 �6 6
AUX IN
2.
Place the BA-330 on a flat and level surface.
• When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
• When using the arm stand, always be sure to place it so the BA-330
remains level.
• When not using the arm stand, fold it up.
• Never lift up and carry the BA-330 by holding the folding stand.
• Never place any objects on top of the BA-330 when using the arm
stand. Also, never sit or lean on the folding stand.
• When folding the folding stand, be careful not to pinch your fingers.
Convenient Features
Arm stand
CAUTION
15