INTRODUCTION
This is an engine-driven transfer pump for use in general de-watering applications and is suitable for pumping clear water. Do not use the pump in
applications where sewage or any other debris (gravel, sand, floating debris, etc.) or corrosives are present.
This instruction sheet provides you with the information required to safely own and operate your product. Retain these instructions for future reference.
The product you have purchased is of the highest quality workmanship and material, and has been engineered to give you long and reliable service. This
product has been carefully tested, inspected, and packaged to ensure safe delivery and operation. Please examine your item(s) carefully to ensure that no
damage occurred during shipment. If damage has occurred, please contact the place of purchase. They will assist you in replacement or repair, if required.
APPLICATION
Use this pump for water only, where the vertical suction head from the water level is 25 ft (8 m) or less. Do not exceed the maximum suction head.
Head refers to the height of a column of water that can be delivered by the discharge of the pump (Figure 1). Suction head (or suction lift) is the
vertical distance between the center of the pump and the surface of the liquid on the suction side of the pump. Discharge head is the vertical distance
between the pump's discharge port and the point of discharge. Total head is the sum of the suction head and the discharge head. The elevation above
sea level and friction losses must be taken into consideration.
SPECIFICATIONS
Engine
Performance
Fuel Type
Oil Type
Shut Off
Suction head (max.)
Intake Size
Discharge Size
Maximum Flow
Weight
Height
Width
Length
4
Model
6RLAG-2LST
Air Cooled, 4 Stroke, OHV, 208 cc
6.5 HP @ 3600 rpm
Refer to engine manufacturer's owner's manual
Refer to engine manufacturer's owner's manual
92 ft (28.0 m)
25 ft (7.62 m)
2" MNPT (5.08 cm)
2" MNPT (5.08 cm)
150 GPM (568 LPM)
60 Lb (27.2 kg)
15.5" (39.4 cm)
14.5" (36.8 cm)
18.0" (45.7 cm)