Publicité
Les langues disponibles
Les langues disponibles
To do a check of the vibration damping system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
2. Push the start/stop switch down to the STOP
position. The engine must stop.
Your product has the function that adjusts the carburetor
automatically, which gives the best possible adjustment.
lets the engine adapt to weather conditions, altitude,
gasoline and the type of two-stroke oil.
CAUTION:
speak to your servicing dealer. The product
adjusts correctly after some fuelings.
To do a check of the muffler
WARNING:
arrester and spark arrester mounting
face may contain deposits of combustion
particles on the surfaces that may be
carcinogenic. To avoid skin contact and
inhalation of such particles when cleaning
and/or servicing the spark arrester, make
sure you always:
•
wear gloves;
•
clean and/or servicing in an area with
good air flow;
•
do not use pressurized air to clean the
spark arrester screen;
•
use a steel brush and brush away from
your body when cleaning the spark
arrester screen.
WARNING:
has a damaged muffler or a muffler that is in
bad condition.
24
If does not work correctly,
A used muffler/spark
Do not use a product that
WARNING:
the spark arrester screen on the muffler is
missing or damaged.
1. Examine the muffler for damages.
2. Make sure that the muffler is correctly attached to
the product.
Note:
Do not remove the muffler from the product.
3. If your product has a special spark arrester screen,
clean the spark arrester screen weekly.
4. Replace a damaged spark arrester screen.
CAUTION:
is blocked the product becomes too hot
and this causes damage to the cylinder and
piston.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing.
Do not use a product if
If the spark arrester screen
2053 - 001 - 18.04.2023
Publicité
