Leckey Horizon Mode D'emploi page 6

7.2 How to attach the
tray in supine standing
The Tray is attached to and removed from
the frame by the metal brackets located
below the chest pad. To attach the tray
slide the metal bars into the receiving
tubes to the required depth and secure by
tightening the knobs (a) on either side.
7.3 Inserting
Attachment Bolt
Insert the required attachment bolt (a)
along with the retention plate (b). Place a
rubber lid (c) on both, the top and bottom
of the sandal. Fasten using the four screws
(d) provided. To remove or replace the
attachment bolt, reverse this process.
1
A
2
C
D
A
B
3
D
7.4 Attaching the Sandals
Place the sandal so that the attachment
bolt goes through the slot in the footplate.
To secure, on the underside of the footplate
place the rubber washer (a), followed by
the metal washer (b) and then the knob (c)
onto the attachment bolt. To position the
sandals simply loosen the knob (c) under
the footplate, select the position
you require and re-fasten the knob.
1
B
C
2
C
C
A