Publicité
Les langues disponibles
Les langues disponibles
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete. To save energy the
recommended setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
To change the setting:
Press the On/Off button (.
1.
Hold down the function key #
2.
and press the Start button P
until the display 8 indicates
š:‹x (x can be any number).
Release both buttons.
3.
Press the function key # until
4.
the display 8 indicates ˜:‹x.
Press the function key 3 until
5.
the display corresponds with your
requirements.
Press the Start button P.
6.
Switching off the appliance
Short time after the end of the wash
cycle:
Press On/Off button (.
1.
Remove the dishes when they
2.
have cooled down.
Operating the Dishwasher en-us
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
Press On/Off button (.
1.
The LED's go out. The wash cycle
is saved.
To continue the wash cycle, close
2.
the door and press On/Off button
( again.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
35
Publicité
