Publicité
Les langues disponibles
Les langues disponibles
r
NON=USE AND VACATION
CARE
Operate your washer only when you are home. If moving,
or not using your washer for a period of time, follow these
steps:
1. Unplug or disconnect
power to washer.
2. Turn off water supply to washer, to avoid flooding due
to water pressure surge.
r
WINTER
STORAGE
CARE
IMPORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize
washer:
1. Shut off both water faucets; disconnect
and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on RINSE & SPIN cycle for about 30 seconds
to mix antifreeze and remaining water.
3. Unplug washer or disconnect
power.
TRANSPORTING
YOUR WASHER
1. Shut off both water faucets. Disconnect
and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect
drain from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer basket.
6. Drape power cord over edge and into washer basket.
7. Place packing tray from original shipping materials
back inside washer. If you do not have packing tray,
place heaw blankets or towels into basket opening.
Close lid and place tape over lid and down front of
washer. Keep lid taped until washer is placed in new
location.
r
RE! NSTALLING/USI
NG WASHER
AGAI N
1=
2.
To
1.
To reinstall washer after non-use, vacation, winter storage,
or moving:
Refer to "Installation Instructions"
to locate, level, and
connect washer.
Before using again, run washer through the following
recommended
procedure:
use washer again:
Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
2. Plug in washer or reconnect power.
3. Run washer through BULKY ITEMS cycle to clean
washer and remove antifreeze, if used. Use only HE
High Efficiency detergent. Use 1/2 the manufacturer's
recommended
amount for a medium-size
load.
11
Publicité
