INTERNAL LAYOUT
DOOR BINS
DOOR BINS
The door bins are adjusted by lifting the bin upward
and sliding into the desired position. The lower door
EN
bin has a retaining support to keep taller items from
falling out. The upper door bins do not have the
support and are meant for storage of shorter items.
The door bins are easily removable for cleaning. To
remove a door bin from the door, remove the top
cap of the left and right side ladder then slide the bin
upward and out.
USING THE ICE MAKER
USING THE ICE MAKER
To activate the ice maker after installation of the appliance, see ICE MAKER instructions on
page 19.
Please note that 12 to 24 hours are necessary before ice production may begin. The production
is 10 cubes per cycle, approximately 10 cycles in 24 hours.
The yield depends on the temperature set in the freezer, the room temperature and the
frequency of door opening. If the appliance is operating without being connected to the water
system, make sure that the ice maker is deactivated.
The ice maker produces ice until the ice tray is full and will automatically stop once the
maximum level is reached.
With the Fast Ice function, it is possible to increase the quantity of ice produced in 24 hours,
while the Set Cube Size function permits selection of the size of the produced ice cubes.
NOTICE
If the ice is not used frequently, it is advisable to empty the ice bin once every 8-10 days.
It is normal that some ice cubes stick to one another. If the ice is not frequently used, the older
cubes can become opaque, will have an odd flavor and become smaller.
The ice maker automatically deactivates if and when the Holiday function is activated.
When the ice maker is started for the first time, it is recommended to dispose of the first full
bin of ice.
If the equipment has been switched off for a month or more, it is recommended to perform a
manual cleaning cycle.
KRB/KRP models: The ice maker will only produce ice with the FreshSelect
to Freezer Mode.
All models: The ice maker will continue to operate even when the ice bin is not in position.
30
©2022 Hestan Commercial Corporation
(CONT.)
2
1
™
™
compartment set