Control panel function introduction
1. "DOWN" button: Control the piston to move down.
2. "UP" button: Control the piston to move up.
3. Alarm light: When the light is red, the motor has popped the circuit. At that time, "UP" & "DOWN" buttons,
and the foot
4. ON light: When the light is green, the motor is powered on.
5. "STOP" button: Stop the piston moving at any time.
6. ON/OFF switch: Connect or disconnect power.
7. Circuit breaker: Trips to protect the motor when the motor overloads.
8. The speed control knob: Adjust the speed of the piston, the pedal will not work. Please refer to the circuit
breaker section.
9. Sensor Plug: Plug into the stuffer to engage sensor to automatically stop piston at bottom and top of
cylinder.