Hama MagPower 5 Mode D'emploi page 4

4.1. Charging the MagPower 5
• Push the MagPower 5 power pack with the induction charging area pointing forwards into the holder
(6) on the 2in1 wireless stand.
• The USB plug (7) integrated into the holder connects to the USB-C port integrated into the power pack
and makes a click sound.
• Charging of the power pack starts automatically as soon as the 2in1 wireless stand is connected to the
included 30W PD charger.
• Once the charging process is complete, the status LED (8) goes out.
Note – capacity
When the power pack is being charged in the holder, the capacity display is not visible. The charging
function is only indicated via the white status LED (8) on the front of the holder.
• Alternatively, start the power pack charging process by connecting the enclosed USB-C cable to the
USB-C port on the power pack (IN 5 V / 2 A or 9 V / 1.5 A) and to a suitable USB charger. To do this,
consult the operating instructions for the USB charger you are using.
• The charging process begins and ends automatically.
• Fully charge the power pack once before using it for the first time.
Note – capacity
• During the power pack charging process, the capacity is displayed constantly.
• Each LED (4) corresponds to 25% of the capacity. The permanent illumination of an LED indicates
that the capacity has already been reached. If three LEDs light up and the fourth one flashes, the
power pack is at least 75% charged.
• If all four LEDs (4) light up, the full capacity is available.
• Press the button on the power pack to switch this on, to determine the power pack's current
capacity and to start the wireless function.
• The power pack switches itself off after around 40 seconds of non-use. Press the Power button
twice to switch the power pack off manually. When the power pack switches off, the LED display
also goes out.
Warning - rechargeable battery
• Do not charge the power pack via your PC or notebook. The charging currents can damage the USB
port on the PC or notebook.
• Only use suitable charging devices or USB ports to charge the product.
• Do not use defective chargers or USB ports and do not attempt to repair them.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
• When stored over a long period of time, batteries should be charged regularly (at least every three
months).
4.2. Charging devices with the MagPower 5 Power Pack
4.2.1. Wireless charging with the induction charging zone:
• first switch the power pack on using the Power button on the underside of the holder.
• The blue function LED (2) briefly indicates the power pack's ready state and then switches off.
• Place your device with its back on the inductive charging zone (B).
• The "MagPower 5" power pack is compatible with Apple MagSafe technology. The correct alignment
and fixation of the device takes place automatically thanks to the magnets integrated into the power
pack and the iPhone.
• All other smartphones that support the inductive charging function should also be placed on the
induction charging zone (B). In this case, however, the automatic central fixing of the device does not
take place.
3