Worx Nitro WG325E Mode D'emploi page 15

1/3
illustrated in Figure 4, cut 1/3 the diameter from
the top (overbuck) (1). Then make the finished cut
by underbucking (2) the lower 2/3 to meet the first
cut.
1
1/3
1
1/3
Figure 4
1
When bucking on a slope always stand on the
uphill side of the log, as illustrated in Figure 5.
1/3
When "cutting through", to maintain complete
control release the cutting pressure near the end
of the cut without relaxing your grip on the pruning
saw handles. Don't let the chain contact the
ground. After completing the cut, wait for the saw
chain to stop before you move the pruning saw.
Always stop the motor before moving from tree to
tree.
Figure 5
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Cordless Pruning Saw
2/3
2
2/3
2
2/3
2
2/3
Wear eye protection
Wear dust mask
Wear head protection
Beware of pruning saw kickback and
avoid contact with bar tip
Do not expose to rain
Wear protective gloves
Wear protective footwear
Warning of danger from overhead
electric-power lines
Do not burn
Batteries may enter water cycle if
disposed improperly, which can
be hazardous for ecosystem. Do
not dispose of waste batteries as
unsorted municipal waste.
Waste electrical products must
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
15
EN