Lubrication - Ryobi ESS-3215V Manuel D'utilisation

GB
F D
work with any of these materials, it is extremely important
to clean the tool using compressed air.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
MAINTENANCE

LUBRICATION

All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore,
no further lubrication is required.
CLEANING THE SCRUBBING PADS
To ensure longer life and optimum performance,
periodically clean all sanding residue and foreign
materials from the scrubbing pads. This can be done
simply by rinsing the pad with warm water untill all foreign
material has been washed away. After cleaning, gently
squeeze the pad to remove excess water and allow
pad to dry. Always store pads and sanding sheets flat in a
cool dry location.
CLEANING THE SANDING SHEETS
The sanding sheets that came with your sander are
made to be re-used. Therefore, it is important that they
be cleaned periodically to remove sanding residue and
E I P NL S DK N FIN GR
English
foreign material that can accumulate over time.
13
RO
H CZ RUS
To clean sanding sheets, rub the sheets
with a hard rubber block. You can also use
the clean rubber sole of a shoe.
WARNING
Always remove scrubbing or
sanding pad from sander before
cleaning. Failure to do so could cause
serious personal injury.
HR
PL SLO TR