All manuals and user guides at all-guides.com
These are configuration parameters:
•
Virtual Circuit:Enable
•
Encapsulation: There are 3 ways :1483 Routed IP LLC, 1483
Routed IP VC-MUX or Classical IP over ATM ( RFC 1577). You
have to check with your ISP about which way is adopted.
•
Bridge:Disable
•
VPI:0 or 1 (Consult the ISP)
•
VCI:38 or 50 (Consult the ISP)
•
IP Adress: Insert your Public IP
•
Subnet Mask: Insert Netmask provided by ISP
•
Gateway: Insert router Default Gateway
Press Submit and then click on Save Config.
Press again Submit. to reboot the Router.
To this point approaching the section Status you will be able to check if
connection is up, now you can begin navigation. For every other problem
refer to manual on attached cd-rom.
ENGLISH
24