Lux Tools STS-750/85 Mode D'emploi page 30

All manuals and user guides at all-guides.com
Stichsaege_380385.book Seite 30 Mittwoch, 25. Januar 2017 10:57 10
GB
• Incorrect use of the product;
• Unsuitable tools inserted;
• Unsuitable material;
• Insufficient maintenance.
You can reduce the risks considerably by following
the tips below:
– Maintain the device in accordance with the
instructions in the operating instructions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and your
hands, in particular, are kept warm.
– Take regular breaks and move your hands at the
same time to promote circulation.
Remaining risks
There will still be residual risks even when the device
is used according to the instructions and under
observation of all of the safety notes in this set of
operating instructions:
• Touching the tool in the uncovered section.
• Reaching into the operating tool.
• Kickback from work pieces and work piece
parts.
Personal protective clothing
Wear goggles when working with the de-
vice.
Wear ear defenders when working with the
device.
When working with tools that cause con-
siderable dust, wear a dust protection
mask.
Do not wear protective gloves when work-
ing with the device.
Wear tight fitting clothes when working
with the device.
If you have long hair, cover or wear a hair
net.
Your device at a glance
► P. 3, item 1
1. Stroke regulator
2. Switch for pendulum stroke
3. Saw blade
4. Foot plate
5. Dust protection
► P. 4, item 2
6. On/Off switch
7. Locking button for continuous operation
8. Locking screw for parallel stopper
9. Shaving rejection chute
Scope of delivery
• Jig-saw
• Saw blade (3×)
• Allen key (1×)
• Parallel stopper
30
• Operating instructions
Using for the first time
Fitting the saw blade
DANGER! Risk of injury! Pull out the
power plug before conducting any mainte-
nance work on the device.
WARNING! Risk of injury! Shortly after
sawing, the saw blade may be very hot.
Risk of burning! Allow a hot blade to cool
down. Never clean a hot saw blade with
flammable liquids.
CAUTION! Risk of injury! Even a saw
blade which is at a standstill can still cut!
Always wear gloves when replacing the
saw blade.
► P. 4, item 3
Suitable saw blades: ► P. 4, item 4, ► Technical
data – p. 32.
– Twist the locking sleeve (10) by 90° and hold.
– Place the saw blade (3) as far as it will go into the
holder.
– Release the locking sleeve (10).
– Ensure that the blade is securely fitted into
place.
Operation
Check before switching on!
Check to make sure the unit is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all unit components are cor-
rectly mounted.
Switching on and off
– Switching on: Press the On/Off button (6).
– Switching off: Release the On/Off switch.
– Permanent operation: Press the locking button
with the On/Off switch (7) held down.
– Set the required stroke rate with the rotating reg-
ulator (1).
Setting the cutting angle
The unit allows you to set a cutting angle of up to 45°.
► P. 5, item 5
– Loosen the screws (11).
– Swing the foot plate (4) into the required angle.
– Tighten the screws (11) back up again.
Setting the pendulum stroke
– Set the pendulum stroke with the switch (2):
– Switch setting [0] = Hard material
– Switch setting [1–3] = Soft material
Note: A higher pendulum stroke setting
increases the cutting speed, but may lead
to rougher cut edges.