HIKOKI DS18DC Mode D'emploi page 14

English
CAUTION
○ If the battery is charged while it is heated because
it has been left for a long time in a location subject to
direct sunlight or because the battery has just been
used, the charge indicator lamp of the charger lights
for 0.3 seconds, does not light for 0.3 seconds (off for
0.3 seconds). In such a case, fi rst let the battery cool,
then start charging.
○ When the charge indicator lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign objects in
the charger's battery connector. If there are no foreign
objects, it is probable that the battery or charger is
malfunctioning. Take it to your authorized Service
Center.
MOUNTING AND OPERATION
Action
Removing and inserting the
battery
Charging
Installing / Removing the side
handle
Tightening torque adjustment
Selecting the drill position
Selecting the impact position
Change rotation speed
Mounting and removing the hook
How to use the LED light
Mounting the bit
Reversing the rotational direction
Switch operation
Remaining battery indicator
Charging a USB device from a
electrical outlet
Charging a USB device and
battery from a electrical outlet
How to recharge USB device
When charging of USB device is
completed
Selecting accessories
RFC (Reactive force control)
This product features RFC.
This stops the motor automatically if the tool is jerking
excessively.
The LED light fl ashes to indicate that RFC has been
activated.
If this occurs, release your fi nger from the switch before
restarting. (Fig.16)
NOTE
● RFC may not always activate under certain working
● Take care to hold the tool fi rmly to prevent any jerking
● RFC may also activate if you change position suddenly
LED LIGHT WARNING SIGNALS
Figure Page
3 2 This product features functions that are designed to protect
the tool itself as well as the battery. If any of the safeguard
4 2
functions are triggered during operation, the LED light will
blink as described in Table 5. When any of the safeguard
5 3
functions are triggered, immediately remove your fi nger
from the switch and follow the instructions described under
6 3
corrective action.
7 3
8 3
Safeguard
9 3
10 4
11 4
12 4
13 4
Overburden
Protection
14 4
15 5
17-a 5
17-b 5
18 5
RFC
19 6
― 230
Temperature
Protection
14
conditions or situations.
motion.
while holding the tool.
Table 5
LED Light Display
Function
On 0.1 second/off
0.1 second
(rapid blinking)
Blinks for
approximately
3 seconds after the
switch has been
released.
On 0.15 second/off
0.15 second ×
3 times/Off
2 seconds
Blinks for
approximately
3 seconds after the
switch has been
released.
On 0.5 second/
Off 0.5 second
(slow blinking)
Blinks while
protection is in eff ect.
Corrective Action
If the operating
with the shift knob
set on "2", adjust
to "1" and continue
operation.
Remove the
cause of the
overburdening.
Remove the
problem causing
the tool to jerk
excessively.
When operating
the tool, fi rmly hold
the tool to make
sure it doesn't jerk.
Allow the tool
and battery to
thoroughly cool.