Kärcher CNS 36-35 Battery Mode D'emploi page 41

The distance between the guide rail and the chain
must be ca. 5,5 mm.
5. Tighten the chain tensioner knob.
Replacing the chain and guide rail
CAUTION
Sharp chain
Incision injuries
Wear protective gloves when working on the chain.
1. Remove the battery pack (see chapter Removing
the battery pack).
2. Release the chain tensioner knob and remove the
bar cover.
Illustration AD
3. Remove the guide rail with the chain tensioner.
Illustration AE
4. Remove the chain tensioner if the guide rail is to be
replaced.
Illustration AF
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Fault
The device does not start
up
The device stops during
operation
Warranty
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Troubleshooting guide
Cause
Battery pack is empty
Battery pack is defective.
Battery pack is not inserted correctly.
The battery has overheated
Motor has overheated
5. Dispose of the old chain and, if necessary, the guide
rail properly.
6. If necessary, mount the chain tensioner on the new
guide rail.
Illustration AG
7. Fit the new chain on the guide rail. Observe the di-
rection of rotation of the chain.
Illustration C
8. Place the chain around the sprocket and insert the
guide rail.
Illustration D
9. Fit the bar cover and tighten the chain tensioner
knob.
Illustration E
10. Adjust the chain tension (see Chapter Adjusting the
chain tension).
As the battery pack ages, even if it is looked after, its ca-
pacity reduces such that the full run time will no longer
be reached when fully charged. This does not indicate a
defect.
Rectification
 Charge the battery pack.
 Replace the battery pack.
 Push the battery pack into the mounting
until it latches into place.
 Stop working and allow the battery to cool
down to normal battery temperature.
 Stop working and allow the motor to cool
down.
Technical data
Device performance data
Working voltage of the battery
No-load chain speed
Chain oil tank volume
Determined values in acc. with EN 60745-1, EN
60745-2-13
Sound pressure level L
Uncertainty K
pA
Sound power level L
Uncertainty K
WA
Front handle hand-arm vibration
value
Rear handle hand-arm vibration
value
Uncertainty K
Dimensions and weights
Length x width x height
Guide rail length
Cutting length
Chain pitch
Weight (without battery pack)
Subject to technical modifications.
English
V
m/s
ml
dB(A)
pA
dB(A)
dB(A)
wA
dB(A)
2
m/s
2
m/s
2
m/s
mm
mm
mm
in (mm)
kg
36
21
190
91,2
3,0
102,2
1,8
3,6
4,9
1,5
834 x
222 x
235
356
300
0,375
(9,525)
4,3
41