LG WM3477HW Guide De L'utilisateur Et D'installation page 31

BEFORE CALLING FOR SERVICE
Problem
The display shows:
The display shows:
The display shows:
The display shows:
The display shows:
The display shows:
Staining
Banging noise when
washer is filling
with water (Water
Hammer)
The display shows:
(cont.)
Possible Causes
• Load is too small.
• Load is out of balance.
• The washer has an imbalance
detection and correction
system. If individual heavy
articles are loaded (bath
mat, bath robe, etc.) and the
imbalance is too great, the
washer will make several
attempts to restart the spin
cycle. If an imbalance is still
detected, the washer will stop
and the error code will be
displayed.
• Control error.
• Water level is too high due to
a faulty water valve.
• The water level sensor is not
working correctly.
• Thermal overload protection
circuit in the motor has been
tripped.
• A power failure has occurred.
• Add laundry products to the
washer drum.
• Washer not unloaded
promptly.
• Does not properly sort the
clothes.
• Plumbing in the home moves
or fl exes when the water
valves in the washer shut off.
• Household water supply
pressure is very high.
• Check water supply.
T R O UB L E SH O O T I N G T R O UB L E SH O O T I N G
Solutions
• Add 1 or 2 similar items to help balance the load.
• Rearrange items to help balance the load.
• Unplug the washer and call for service.
• Close the water faucets, unplug the washer, and call
for service.
• Close the water faucets, unplug the washer, and call
for service.
• Allow the washer to stand for 30 minutes to allow the
motor to cool; then restart the cycle. If the LE error
code still appears, unplug the washer and call for
service.
• Restart the cycle.
• Load the laundry products into the dispenser.
• Always remove items from the washer as soon as
the cycle is completed.
• Always wash dark colors separately from light colors
and whites to prevent discoloration. If possible, do
not wash heavily soiled items with lightly soiled
ones.
• Water hammer is not caused by a defect in the
washer. Install water hammer arrestors (purchased
separately at hardware or home improvement store)
between the fi ll hose and the washer for best results.
• Adjust household water supply regulator to a lower
pressure or contact a plumber to have a regulator
installed.
• Turn the faucet on. If "
unplug power plug and call for service.
" error code persists,,
31