Publicité
Page 3 of 9
FITTING INSTRUCTIONS
To fit R&G radiator guard to the bike, insert the 4x rubber grommets into the radiator guard
•
in the holes circled in yellow in Assembly Diagram if they do not come already installed.
It may be necessary to remove the fairing in order to remove the OEM radiator guard,
•
please refer to the owner's manual for further information.
Remove the two bolts holding the OEM guard in place at the top, behind the steering
•
damper, then remove the OEM guard by lifting it slightly to allow it to slide out downwards.
Place the new radiator guard onto the radiator and fasten the two bolts at the top of the
•
radiator using the original bolts removed.
Fit cable ties through radiator guard and bottom tabs on the radiator, cut any excess visible
•
cable tie.
Refit all fairing panels & check all bolts are tight before riding.
•
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make
design changes which do not diminish their performance or visual appeal and supplying them in such state shall
conform to the order. The Buyer acknowledges no representation or warranty (other than as to title) has been given or
will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it has chosen the
Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or
undertakes other services it shall exercise reasonable skill and care and rectify any fault free of charge unless the
workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not
affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or
maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if
the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for
causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall
be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not
affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to
us if they were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original
vendor. Goods must be in re-sellable condition, in the opinion of R&G. All returns are subject to a 25% restocking and
handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay
any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does
not affect your statutory rights and does not refer to faulty goods.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 – 26/07/2023 (MH)
CONSUMER NOTICE
R&G RETURNS POLICY (NON-FAULTY GOODS)
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G
www.rg-racing.com
Email:
RAD0326PRO
info@rg-racing.com
Publicité
