Outsunny 840-245V80 Instructions D'installation page 14

Note:
a)If you press the learn button for more than five seconds, the motor will not vibrate.
You should turn off the power and try again.
Step2. Set the Opening Stop Position.
Note:
a) The open limit is about one meter , that means the motor will stop when the
awning is opened for about one meter. At this time, you can continue adjust the
pointed nuts to "+",until it reaches the ideal open position.(The awning is fully
opened and the fabric is tensioned.)
b) When you set the open limit, if the motor still does not stop when open awning to
the appropriate position, close the awning and open it again. While it is opening,
adjust the same pointed nuts to "-"(clockwise),until it stop. Then adjust the pointed
nuts to"+" ,until it reaches the ideal open position.(The awning is fully opened and
the fabric is tensioned.)
Power On, Press the
Down button to move the
awning running open.
Step3. Set the Close Stop Position.
Note:
a) The close limit is near the close position. When it stop, you can continue adjust
the pointed nuts to "+",until it reaches the ideal close position.
b) When you set the close limit, if the motor still does not stop when close awning to
the appropriate position, press the open button to open the awning and close it
again. While it is closing,adjust the same pointed nuts to "-"(clockwise),until it stop.
Then adjust the pointed nuts to"+" ,until it reaches the ideal close position.
Power On, Press the
Up button to move the
awning running close.
If the open limit needs to
be moved outwards,
adjust the pointed nuts
to"+".
If the close limit
needs to be moved
inwards, adjust the
pointed nuts to"+" .
13
When the motor is in still and
not running, do not adjust the
limits nuts.
The open
limit is set.
When the awning reaches
the ideal open position,
stop turning the nuts.
Press the Stop button.
When the motor is in
still and not running,
do not adjust the
limits nuts.
The close limit is set.
When the awning reaches the
ideal close position, stop
turning the nuts.
Press the Stop button.