Publicité
Les langues disponibles
Les langues disponibles
Step 1: Unboxing.
Carefully remove the awning from the box and remove the styrofoam protectors
from the awning, remove the plastic bags and plastic guards from the awning and
carefully place the awning aside to avoid having it damaged by scratches or
otherwise damaged or soiled during assembly.
Think about how you will be securing the awning to the wall ahead of time. In case
you would like to mount it above a patio door, you should leave a space of at least 8
inches (20cm) above the door frame. If there is enough space available above the
door frame.
The approximate total drop area of the awning is around 12-20 inches (30-50
cm),Ensure that you also take this drop height into account in your decision on
where to install the awning.
The drop angle can and may only be changed minimally.
Picture 1: it shows the drop still be changed after assembly. The ideal drop angle,
however, has already been set in the factory of the awning when it is fully extended.
(Total drop, height of front bar more than 8 Feet (≥2.5 meters), cross section of the
wall, bracket height).
Step 2: Location of the wall brackets
Location (a) - Between the right end of the awning and the right Arm. (facing the
awning) on the fabric tube.
Location (b)- Only available for 3.5m and 4m.
Location (c) - Between the left end of the awning and the left Arm.
Measure the width of the awning with a ruler and note the positions of wall brackets.
Picture 2:Draw a horizontal line at the height of the required areas as illustrated in
the image and use a long ruler, a level and chalk for this purpose. Mark the
corresponding places on the wall by running a pencil through the holes at the
bottom of the brackets.
Location(a)
Location(b)
Wall brackets
Wall
brackets
Only Available for 3.5m and 4m.
9
Wall
brackets
Location©
Publicité
