Outsunny 840-245V80 Instructions D'installation page 12

Step 5: Now your awning can be secured to the wall brackets.
Picture 5:At least two ladders or chairs are required to install the awning in order to
obtain the required height. Ensure that the ladders or chairs are firmly stay on the
ground so that you can't fall.
Use ladders that are suitable for such assembly work.
Note:
In case the pole( wall bar) can' t be inserted into the wall brackets, you should
slightly loosen the wall brackets screws and then try it again.
This time, move the awning slightly forward and backward until the pole slips into
the brackets.
Then immediately insert the safety bolts on the front side of the wall brackets and
tighten the nuts with a 19mm hex key.
Ensure that the safety bolts for the wall brackets have been tightly secured.
Note: Now you could remove the safety sleeves from the arms.
Step 6: Changing the Pitch
There is one final adjustment you might need to make. It is setting the pitch or angle
of your awning. Fully open the awning.
Are you happy with the height and level of the front bar? If so, great!
You are done with the installation. Relax, and enjoy your awning.
If not, you can adjust the pitch or angle of each arm separately.
1. Fully open the awning using your crank or remote transmitter on motorized
awning, unplug the power cord from the outlet after opening the awning.
2. Using 17mm wrench to loosen the two locking nuts on the side, then use 14mm
wrench to loose the jack bolt on the arm shoulder.
--See figure 6
WARNING: RAISING THE FRONT BAR WILL REDUCE THE PITCH (ANGLE) OF
THE FABRIC THUS INCREASING THE RISK OF RAIN WATER POOLING ON THE
FABRIC.
TO PREVENT THE AWNING FROM COLLAPSING DUE TO RAIN WATER LOAD,
YOU MUST RETRACT THE AWNING WHEN UNATTENDED. FAILURE TO DO SO
COULD RESULT IN PERSONAL INJURY.
If you have any questions about installation or if you require spare parts, please
contact your dealer.
BE SURE TO NOTE.
The awning's gear box does not have stop limits of the roller revolutions. Therefore,
to avoid damaging of the fabric, it must always be properly roller up. The fabric
should be stretched tightly.
11