Télécharger Imprimer la page

GE Profile PR06DSATB Serie Manuel Du Propriétaire page 6

Publicité

Les langues disponibles

Les langues disponibles

Installation Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• Save these instructions for local inspector's use.
Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions for
future reference.
Skill level – Installation and service of this
appliance requires a qualified RV technician
Completion time – Approximately 1 hour
We recommend that two people install this
product.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the warrant
LOCAL INSTALLATION
REGULATIONS
This appliance must be installed in accordance with all
applicable local and national codes, including but not
limitted to the latest editions of the following standards:
• ANSI/NFPA70, National Electrical Code
• ANSI/NFPA 1192, Recreational Vehicles Code
• ANSI Z223.1 National Fuel Gas Code
• ANSI Z21.10.1, Storage Gas Water Heaters
• ANSI A119.5 Park Model RV Standard
• CSA C22.1, Parts I & II, Canadian Electrical Code
• CSA Z240 RV Series, Recreational Vehicles
6
Recommended Tools and Materials
• Drill
• Phillips head screwdriver
• Pipe thread sealant
• Pipe wrench or equivalent
• 2" x 2" lumber (blocking)
• Caulk and Caulk gun
• Ruler or tape measure
Wire stripper
UL approved wire nut or crimp connection
CAUTION
CAUTION
CAUTION
CAUTION
Be cautious of sharp edges as they may cause injury.
When lifting the water heater, use 2 people to lift.
DANGER
Carbon mononxide poisoning hazard.
This water heater can produce carbon monoxide,
which is an odorless and life threatening gas. Follow
these instructions for proper installation of this
appliance.
Warning
Fire and/or Electrical Shock Hazard. Failure to
obey the following warnings could result in
death or serious injury.
Shut of the gas supply, disconnect the 120 VAC
power to the RV, and disconnect the 12 VDC battery
connection before installing this water heater or
drilling/cutting into the RV. Make sure there are no
electrical wiring or piping inside the RV wall at the
installation location.
Warning
Electrical grounding instructions.
This appliance is equipped with a three-prong plug
for your protection against shock hazards and should
be plugged directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding prong from this plug. Failure to obey this
warning could result in death or serious injury.

Publicité

loading

Ce manuel est également adapté pour:

Profile pr10dsatb serieProfile pr06dsatba