BEMIS FLOW CLASSIC Mode D'emploi page 6

Exposing this product to corrosive substances
or sharp objects may cause the hoses to rust
or become damaged. Install in a proper area
to avoid the risk of leaking.
1. Single Hole or Three Hole Installation
Single Hole
- There is an existing black O-ring located at the bottom of the
faucet. Fit the faucet to the mounting hole on the sink.
1. Slide the rubber washer over the hoses and data cable.
Slide the metal washer over, and lastly the mounting nut.
2. Tighten the screws with a Phillips screwdriver.
Three Hole - Remove the black O-ring at the bottom of the faucet. Insert the
deck plate over the hoses in the mounting shank, and then mount the
faucet on the sink.
1. Slide the rubber washer over the hoses and data cable.
Slide the metal washer over, and lastly the mounting nut.
2. Tighten the screws with a Phillips screwdriver.
2. Connect Hot & Cold Supply Lines
Connect the hot and cold supply lines onto the matching water valves
and secure the connection with an adjustable wrech. Avoid hose crimping.
The hoses are color coded for convenience.
10
Above sink
Below sink
Deck Plate
*For Three-Hole Install ONLY
Rubber Washer
Metal Washer
Mounting Nut
Mounting Screws
11