Publicité
Les langues disponibles
Les langues disponibles
Reinstalling the Oven Door(s)
WARNING
To avoid personal injury or damage to the door from it falling off its hinges:
•
Make sure that the notch on the bottom of each hinge rests on the lower lip of each hinge receptacle before
trying to open the oven door.
•
Flip the hinge locks toward the front of the range immediately after installation of the door.
Grasp the oven door on both sides, and hold it at a 15° angle from the front of the oven. Slide the hinges
1.
into their slots, resting the bottom of the hinge arms on the hinge receptacles. Maintain the 15° angle with
one hand while pushing in on each bottom corner of the door, until the notch on the bottom of each hinge
slips over the lower lip of each hinge receptacle.
NOTE
Wire connector under the right side of the door should be connected.
Adjusting the Door
Steps 1 and 3
Steps 1 and 3
INSTALL_DOP48C96DLS_DA_DG68-01511A-00_EN+MES+CFR.indb 27
INSTALL_DOP48C96DLS_DA_DG68-01511A-00_EN+MES+CFR.indb 27
2.
3.
4.
5.
Hinge
slot
Notch
(hinge bottom)
Ensure the oven doors are parallel and flush. To do this,
use the three bolts (one on the right- upper side, and
one under the each hinge) .The upper bolt adjusts the
door horizontally. The lower two bolts adjust the door
vertically.
To adjust door vertically:
1.
2.
3.
4.
Lower the door to the fully opened position.
Rotate the two hinge locks toward the oven.
Slowly and carefully open and close the door
completely to ensure that it is properly installed.
Remove any packaging from inside the oven(s).
Remove the door, then remove 2 screws on each
door-hinge latch.
Adjust the bolt under each latch.
Re-attach and tighten the 2 screws.
Re-install the door.
English 27
2023-02-23 오전 9:45:28
2023-02-23 오전 9:45:28
Publicité
