Publicité
Les langues disponibles
Les langues disponibles
Installation Requirements
Gas and Electrical Service
•
See below for the recommended location of the gas inlet and electrical junction box/receptacle.
Existing utilities may be used if they are compatible with this range. Check local building codes for allowed
gasvalve locations.
An external manual shut-off valve must be installed between the gas inlet and range so the range's gas
•
supply can be turned on/off. Installation must allow access to the gas shut-off valve when the unit is
installed and access to the remote circuit-breaker panel/fuse box without moving the range.
•
The gas-supply piping and shut-off valve, and the electrical junction box/receptacle must be located so as
not to interfere with the range when it is installed.
•
The junction box and gas-shut off valve must be located so the range can be pulled out for service without
being disconnected.
Model
DOP48C96D**
16
English
INSTALL_DOP48C96DLS_DA_DG68-01511A-00_EN+MES+CFR.indb 16
INSTALL_DOP48C96DLS_DA_DG68-01511A-00_EN+MES+CFR.indb 16
D
5 1/2" (13.9 cm)
6 5/8" (16.8 cm)
Recommended
position for
Recommended
position for
electrical outlet
E
F
8 1/8" (20.6 cm)
Gas stub
G
E
D
F
G
26 5/8" (67.6 cm)
2023-02-23 오전 9:45:25
2023-02-23 오전 9:45:25
Publicité
