Publicité
Les langues disponibles
Les langues disponibles
Stainless steel platform is packed separately.
1.
Remove set screw on bottom of scale.
2. Level the scale. Adjust the four feet and reference
bubble on top of scale to level.
3. Set platform in the locating holes in the top cover.
CAUTION! Do not press down with excessive
force. This can damage the load cell.
4. Attach AC adapter to the power jack on the bottom
of the scale.
ZEROING THE DISPLAY
1.
Press ZERO/ENTER key
before weighing or counting.
NOTE: Scale has an automatic re-zero to
handle minor drifting or material accumulation
on the weighing platform. If the display shows
a weight while the platform is empty, press the
ZERO/ENTER key
TARE
Before weighing items, weigh the container so its weight
can be deducted from the accumulated item weight:
1.
Press ZERO/ENTER
Zero
2. Place the container to be used on the weighing
platform. The display will show its weight. Press the
TARE key
. Container weight will be stored as the tare
Tare
value and is subtracted from the display. Display shows
3. Net indicator is on. When adding items to the
platform, only the item weight will be displayed.
NOTE: Scale can be tared a second time to
show only the weight of the items added after
you press the TARE key
show a negative (-) value if the container is
removed. ZERO indicator will also be on.
WEIGHING A SAMPLE
To determine the weight of a sample:
1.
Place empty container on the platform.
2. Press TARE key
to subtract container weight.
Tare
3. Place sample in container. Display shows weight of
sample less the weight of the container.
PAGE 3 OF 27
All manuals and user guides at all-guides.com
INSTALLATION
Zero
to reset the display to
to zero the scale.
Zero
to re-zero the display.
again. Display will
Tare
5. Power switch is located on the bottom right side of
the scale.
BOTTOM VIEW
OPERATION
PERCENT WEIGHING
0
Scale allows the sample weight to be shown as 100%.
Then, any other weight placed on the scale displays as
a percentage of the original sample.
For example:
1. 350g is placed on the scale.
%
2. Press
key
3. Display shows
4. Remove the 350g weight, then place a 300g weight
on the platform.
5. Display shows
6. Press FUNC key
mode.
NOTE: Scale may jump by large amounts if
small weights are used to set the 100% level.
0
.
PARTS COUNTING
While the display is showing a weight, pressing the
FUNC key
Func
1.
Before starting, tare the weight of container used
and leave the empty container on the platform.
2. Place the number of samples on the scale. The
number should match the predetermined sample
sizes: 10, 20, 50, 100 or 200 pieces.
3. Press the FUNC key
for a sample size of 10 parts.)
4. To change the sample size, press the TARE key
Display will cycle through 10, 20, 50, 100, 200 and
back to 10.
Level Feet
Power Switch
Set Screw
.
%
100.00%
.
85.71%
(300g is 85.71% of 350g).
to return the scale to weighing
Func
starts the parts counting function.
. Display shows
Func
AC Adapter
Jack
P 10
(looking
.
Tare
0417 IH-1649
Publicité
