aldes L1-02 Manuel D'instructions page 5

Operation instructions
Operation modes
Selecting mode
Press button once by once
MODE
The operation modes changed in sequence:
Result :
PRESS
Heating mode is NOT available for cooling only air conditioner.
FAN mode
Press button once by once
FAN SPEED
The fan speed is changed in sequence:
Result :
PRESS
FAN SPEED
At "FAN ONLY" mode, the "AUTO" is not available.
At "DRY" mode, Fan speed is set at "AUTO" automatically, "FAN" button
is ineffective in this case.
Setting temperature
Press button once
TEMP.
Raise temperature setting by 1℃ or 1°F
Result :
Press button once
TEMP.
Lower temperature setting by 1℃ or 1°F
Result :
Turning on
Press button .
T he RUN indicator of the indoor unit lights up.
Result :
SWING, SMART, TIMER ON, TIMER OFF, CLOCK, SLEEP and SUPER operation modes will be specified in the following pages.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
Wait 3 minutes before restarting the appliance.
MODE
COOLING
Auto
Higher
High
3
DRY FAN ONLY HEATING
Medium
Low Lower
Range of available set temperature
*HEATING, COOLING
DRY
FAN ONLY
MODE
*Note: Press and hold "
together for 3 seconds will alternate the temperature display
between the ℃ and °F scale.
*Note: Heating mode is NOT available for cooling only models.
*Note: At "Dry" mode, a decrease or rise of up to 7℃ can be set
with Remote controller if you still feel uncomfortable.
OFF
OFF
16℃~30 61 °F~86°F)
℃(
-7 ~ 7
unable to set
TEMP.
" button and " " button