Publicité
Les langues disponibles
Les langues disponibles
4. With the hardware installed, slide the cantilever upwards so the top edge of the cantilever covers the
window opening in the upright support. Tighten the cantilever.
4
5. Install the load bar hardware to the end of the cantilever support. Leave loose.
Repeat these steps for the second cantilever support. Once completed refer back to MPG920
TradeSport instructions to complete the truck rack installation.
6. With the truck rack installed, add the last load bar to the cantilever support by aligning the square nuts
and t-slot on the underside of the loadbar.
7. Complete the system with the end caps, rubber insert and load stops if required.
When complete, insure the cantilever load bar is level with the front load bar of the
truck rack and adjust as needed.
5
Publicité
