LiftMaster LM60EVS Notice De Montage page 28

DIAGNOSTIC CODE
Up Arrow Down Arrow
Flash(es) Flash(es)
5 1 Terminal 1+2 for wall control is short-
ened longer than 4 seconds
5 5 Low voltage
6 1 Maximum radio memory has been
reached.
34
Optional Accessories
Always use Liftmaster accessories. External products can cause malfunctions.
1. TX4EV/S - 4-channel remote control
2. TX4UNI/S - Universal remote control
128EV - Wireless Wall Control 2-Channel
3.
4. 747EV - Keypad
5. 828EV - Gateway LiftMaster
829EV - Garage Door Monitor
6.
7. EQL01EV - Quick release
8. 1702EV - Quick release
9. 75EV - Wired push button
10. 78EV - Wired multi-functional wall control
11. FLA-1LED - Flashing light
Photocells
12. G770E -
Photocells
771EV/K -
Photocells
772E -
13. 100034 - Key switch (flush mount)
14. 100041 - Key switch (surface mount)
15. 16200LM - Door in Door contact
SYMPTOM
Check wiring for push button if button is stuck and activated permanently. Remove
wiring from terminal 1+2 on operator as test. Do not run push button wires next to high
voltage wiring or in same conduit.
The operator has been shut off due to lower voltage supplied than allowed.
If mains supply is used, check wiring and supply.
Maximum capacity for storage of remote controls has been reached. The first remote
control or more previously programmed remote controls' codes have been replaced by
a new one. To reset diagnostic remove power from the operator.
SOLUTION
en 12/13