Setting Down, Transportation And Storage - Miele Complete C2 Mode D'emploi

en
To open the air inlet valve (dia. 24)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other objects being sucked into the va-
cuum cleaner.
 Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to man-
oeuvre. Close the valve when you are
ready to use full power again.
During vacuuming
 When vacuuming, pull the cleaner be-
hind you on its wheels. You can stand
it upright for vacuuming stairs and
curtains etc.

When vacuuming fine dust, e.g.
sawdust, sand, plaster, flour, talcum
powder etc., electrostatic charges
build up naturally. Under certain con-
ditions these charges will be re-
leased. To avoid the unpleasant ef-
fects of these discharges, a metal in-
lay has been incorporated into the
underside of the handle. Please
make sure that you keep your hand
in constant contact with this metal
strip during vacuuming (dia. 25).
Setting down, transportation
and storage
Park system for pauses during vacu-
uming (dia. 26)
The Park system allows you to conveni-
ently park the suction tube and floor-
head during pauses.
38
 Slot the floorhead into the parking at-
tachment at the back of the vacuum
cleaner.
If your vacuum cleaner is on a slop-
ing surface, e.g. a ramp,
- retract the telescopic tube fully
- do not use the park system if your
vacuum cleaner has an EasyLock
suction tube.
Park system for storage (dia. 27 + 28)

Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
If your vacuum cleaner has an Easy-
Lock suction tube you can separate
the two sections for storage purposes.
 Press the release button on the lower
section and pull the top section out.
 Push the connection piece attached
to the upper tube into the lower tube.
 Stand the vacuum cleaner upright.
If your vacuum cleaner has a tele-
scopic tube, retract the tubes fully so
that it takes up less room for storage.
 Slot the floorhead downwards into
one of the parking attachments on
the sides of the vacuum cleaner.
This makes the vacuum cleaner easier
to carry or store.