Publicité
Les langues disponibles
Les langues disponibles
Signal devices
The watercraft shall be equipped with a towing streamer/flag in
order to advise other watercrafts that towing is occurring.
Maintaining and monitoring proper inflation
It is important to monitor the amount of air in your product as heat
will cause the bladder to expand, possibly damaging seams or
l-beams. If you leave a full tube sitting in the sun for any length of
time it will expand. Either store it in the shade or let some air out.
Don't leave your product on the beach, dock, or boat full of air! If
the product is stored out of the sun in a cool place, you may need
to add some air. Check and adjust the inflation level each time
you use your product for maximum performance and enjoyment.
MAINTENANCE, STORAGE AND REPAIR
Maintenance and storage
When taking the product out of the water, pull it out using the front
towing strap so the water is able to drain out of the drains in the
bottom back. Allow the towable to dry completely to prevent
mildew. If using in salt water, rinse the product with fresh water
and allow to dry completely before storing. For cleaning, use only
water or soapy water. Release all of the air from the chambers
and fold the towable. It is best to store the product inside a warm,
dry area. Do not unfold the product at temperatures below 15°C
(59°F) and do not expose it to frosty temperatures, as it can
damage the material and cause cracks in the PVC bladder. Do not
expose the product to direct sunlight, UV radiation causes colors
to fade and accelerates aging.
14
Repair
Smaller holes or cracks in the bladder can be repaired with the
enclosed repair kit as follows:
1. Please clean and dry the deflated product.
2. Align small defect areas (pinholes and cracks) up to about
2inches(5cm) length one another carefully and apply a thin coat
with repair glue, let it dry for about 10 minutes with warmth (sun).
Then repeat this process every 10 minutes up to 5 times. An
adhesive applied does not need to be removed.Adhesive must be
dry before applying the next layer.
3. In case of a larger defect, apply a 1/2 cm wide thin layer of glue
on the damaged edge and put on the cutted foil patch right away
and press firmly. Repaint edge of patch after about 10 minutes
and repeat according point 2. Too much glue makes the material
soft and prolongs the repair time.
4. Item must necessarily rest 12 hours before use.
5. Don't let the tube be vulcanized, do not use a different
adhesive.
6. The repair must be performed only by adults. Keep adhesive
and fabric patches away from children! Avoid skin contact! Protect
your eyes! Do not swallow! Use only in well ventilated room! Not a
toy!
Before reuse, the product should be carefully checked.
15
Publicité
