Vermeiren Luna 2 Mode D'emploi page 23

1. Insert the stop  and screw  (lowest hole  slatted frame lowest position; highest
hole  slatted frame highest position).
Loosen the locknuts , if necessary.
2.
Insert the bolt rails  on the right and left in the upper wood slat . Insert the bolt
3.
rails  right and left in the lower wood slat .
Slide the entire bolt rails  + wooden slats  in the relevant sliding rail  from the
4.
head and foot panel. Grasp the upper wooden slat upwards until the wooden side rail
locks in position.
Insert the locknuts  and tighten them manually.
5.
Repeat these steps for the other side.
6.
To release the wooden side rails refer to paragraph 2.6.
3.3.4 Wooden side railings (For Luna UL 2)
Adjust the height of the bed in the middle. With a too low height it is not possible to mount
the side rails. With a too high height you must pull the side rails too far upwards.
Loosen the locknuts , if necessary.
1.
Insert the bolt rails  on the right and left in the upper wood slat . Insert the bolt
2.
rails  right and left in the lower wood slat .
Slide the entire bolt rails  + wooden slats  in the relevant sliding rail  from the
3.
head and foot panel. Grasp the upper wooden slat upwards until the wooden side rail
locks in position.
Insert the locknuts  and tighten them manually.
4.
Repeat these steps for the other side.
5.
To release the wooden side rails refer to paragraph 2.7.
Luna 2, Luna Basic 2, Luna UL 2
1 = Bolt rails
2 = Wood slats (2 pieces each side)
3 = Sliding rail
4 = Locknut
Page 21
2016-06