Hilti TE 4-A22 Mode D'emploi page 15

Trouble or fault
The rotary hammer or the
battery gets very hot.
The insert tool can't be re-
leased.
The tool makes no progress.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Mode d'emploi original
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
1.2 Explication des symboles
1.2.1 Avertissements
Les avertissements attirent l'attention sur des dangers liés à l'utilisation du produit.
signalisation suivants sont utilisés :
DANGER
DANGER !
▶ Pour un danger imminent qui peut entraîner de graves blessures corporelles ou la mort.
*2153716*
Possible cause
The rotary hammer has been over-
loaded (application limit exceeded).
The chuck is not pulled back fully.
The rotary hammer has been set to
reverse rotation.
The function selector switch is set
to "Drilling without hammering"
2153716
Action to be taken
▶ Select a tool that is suitable for
its intended use.
▶ Pull the tool lock back as far
as it will go and remove the
accessory tool.
▶ Move the forward / reverse
selector switch to the "Forward"
position.
▶ Set the function selector switch
. to "Hammer drilling"
C'est la condition
Les termes de
Français
.
11