Hilti TE 4-A22 Mode D'emploi page 10

3 Description
3.1 Parts, operating controls and indicators
3.2 Intended use
The product described is a battery-powered rotary hammer. It is designed for hammer drilling in concrete
and masonry, for drilling in steel, wood and masonry and for driving and removing screws.
• Use only Hilti lithium­ion batteries of the B 22 series with this product.
• Use only Hilti-approved battery chargers to charge these batteries. More information is available from
your Hilti Store or from www.hilti.group
3.3 Lithium­ion battery status display
When the lithium-ion battery is used the charge status can be displayed by tapping one of the battery release
buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Indication of the charge status is not possible while the power tool is in operation or immediately after
operation. If the battery charge status LEDs flash, please refer to the information given in the Troubleshooting
section.
3.4 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
The TE DRS-4-A (01) dust removal module greatly reduces dust emissions and is available as an accessory.
6 English
1
Dust shield
@
Chuck
;
Accessory tool release
=
Function selector switch
%
Depth gauge
&
Forward / reverse switch with switch-on in-
(
terlock
Control switch
)
Grip
+
Battery
§
Charge state and fault display (Li-ion battery)
/
Battery release buttons
:
Connection for the TE DRS-4-A(01) dust re-
∙
moval module
Side handle
$
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
2153716
*2153716*