Toro PowerPlex 13in 40V MAX Mode D'emploi page 8

2
Unfolding the Handle
No Parts Required
Procedure
1. Unfold the handle (A of
2. Press and hold the locking button on the upper shaft, align the locking button with the slotted hole on the
lower shaft, and slide the 2 shafts together. Once the slotted hole on the lower shaft is past the locking
button, release the locking button, and slide the lower shaft into the upper shaft until the trimmer is
at the desired height (B of
Note:
Use the locking button only for assembly and disassembly. You do not need to use the button to
adjust the handle.
3. Tighten the lower shaft connector to secure the handle at the desired height (C of
Figure 2).
Figure 2).
Figure 2
7
Figure 2).
g195351