Peltor Wireless Solutions MT53H7AWS2 Mode D'emploi page 13

F. IMPORTANT INFORMATION
The headset must be used, adjusted, cleaned
and maintained in accordance with these user's
instructions.
The headset and the cushions in particular may dete-
riorate with age and should therefore be checked at
regular intervals to make sure that there is no cracking
or sound leakage.
Do not store the headset at temperatures above +55°C,
for example on a dashboard or windowsill.
NOTE! Failure to follow these recommendations may
lead to loss of attenuation and performance.
Clean the exterior of the headset regularly with soap
and warm water.
NOTE! The headset must not be immersed in water.
The headset may be damaged by some chemical
substances. Please contact Peltor for additional infor-
mation.
"This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired opera-
tion."
G. TECHNICAL DATA
Art. no. MT53H7AWS2, MT53H7BWS2, MT53H7P3EWS2
The Peltor WS Headset is designed to comply with the
Bluetooth V.1.2 standard (headset and hands-free
®
profiles) and has been certified in accordance with:
EN 300 328 (radio test)
EN 301 489-1/-7-17 (EMC test)
EN 60 950 (electrical safety, low-voltage directive)
FCC part 15.247 (US and Canada radio test)
The Peltor WS Headset has also been tested and ap-
proved to PPE directive 89/686 EEC, and applicable
parts of the European standards
EN 352-1 :1993/EN 352-3:1996.
Attenuation values are taken from test reports for EC
type-examination certificate, produced by FIOH, Laaja-
niityntie 1, FIN-01620 Vantaa, Finland. ID#0403.
Weight: 390 gr/ 13.75 oz incl. batteries
Attenuation values (Table F:2)
1. Frequency in Hz
2. Average attenuation value in dB
3. Standard deviation in dB
4. APV
Radio specification (Bluetooth
Communication:
Frequency:
Range: Approx.
Transfer rate:
Output:
Frequency hopping:
All manuals and user guides at all-guides.com
):
®
Duplex
2.4–2.5 GHz
10 m (0 dBm)
1 Mbit/second
1 mW (0 dBm)
1600 times/second
9
H. SPARE PARTS & ACCESSORIES
HY79 – Hygiene kit
Easily replaced hygiene kit that consists of two snap-in
attenuation inserts and ear cushions. Replace at least
twice a year to ensure a consistent level of attenuation,
hygiene and comfort.
Clean single-use protectors – HY100A
Hygienic, single-use protector that is easy to apply to
the ear cushions. Supplied in packs of 100 pairs.
Mike Protector – HYM1000
Moisture and wind-resistant and hygienic. Effective
protection that extends the life of the microphone.
Supplied in 5-metre pack that is sufficient for around
50 changes.
Wind muffler for microphone – M995
Effectively reduces wind noise, protects the micro-
phone and extends its life. One per package.
Rechargeable battery – ACK03 (EU), 88009-00000
(US)
NiMH rechargeable battery for replacing 2 x 1.5 V
standard AA batteries in most Peltor products.
Battery cover – 1173 SV
Battery cover made of impact-resistant polypropylene
plastic.