Setting Up The Remote - Sony CDP-CX450 Mode D'emploi

Notes
• Do not connect any player other than the one used as the
second player to the 2ND CD IN jacks of this player.
• When connecting a second CD player, do not connect the
DIGITAL OUT (OPTICAL) connector of this player to the
amplifier.
Changing the command mode of the player
I / 1
1
Press MENU/NO.
2
Turn the JOG dial until "Command Mode?"
appears in the display.
3
Push the JOG dial.
The current command mode appears.
2nd NEXT DISC ART. HIT TRACK GROUP
* C D 1 [ C D ] C 2
ALL 1 DISC S SHUFFLE REPEAT 1 GROUP
PROGRAM 1 2 3 X-FADE DELETE
MULTI CD TEXT NO DELAY CD1 CD2 CD3
Current command mode
4
Turn the JOG dial to select CD1 or CD2, then push
the JOG dial again.
MENU/NO
JOG
ART. MIN STEP SEC
D 3 *

Setting Up the Remote

Understanding the 2-way remote system
The supplied remote operates under a 2-way remote
system. While you use the remote and the remote's
display is on, the component responds to signals sent
from the remote by sending signals back to the remote.
During remote operations, point the remote toward the
player at all times.
To avoid unintentional operations, turn off the 2-way
remote system of this or connected player when:
• you connect via CONTROL A1/CONTROL A1 two
or more components supplied with a remote with the
mark (for example, when you connect this
player to another set of this player or certain
receiver/amplifier). In this case, you need to turn off
the 2-way remote system of the components except
the one you want to use as a main unit for the
system. When you use the remote, make sure to turn
on the main unit.
• you connect this player to a receiver/amplifier
supplied with the RM-TP501, RM-TP501E, or RM-
LJ301 remote control. In this case, you need to turn
off this player's 2-way remote system.
To turn off this player's 2-way remote system, see "To
turn off the 2-way remote system" on page 8.
Getting Started Getting Started
Component
7 GB