Dantherm CDP 35 Instructions De Service page 24

Mounting and installation instructions
Introduction
Mounting of
CDP 35/45/65
Important
Access to the
control
24
All manuals and user guides at all-guides.com
This section contains all necessary information for correct mounting of the duct kit and
the dehumidifier.
The electrical installation is described at the end of this section.
Please follow this procedure to mount the CDP 35/45/65:
Step
1 Fix the wall suspension bar supplies
with the unit to the wall. It is impor-
tant to fix it horizontally in order to
ensure correct condensate outlet.
Recommended distance from dehu-
midifier to:
Ceiling: 225 mm
Floor: 225 mm
2 Hang up the dehumidifier
• Do not place the dehumidifier close to a heating source, e.g. a radiator
• Doors and windows must be kept closed when the dehumidifier is in function
• To make sure that the room air passes freely through the dehumidifier, air inlet and
air outlet openings must be free
Please follow this procedure to get access to the control:
Step
1 Dismount the front Remove the screws (2 pcs.) at the top of the dehumidi-
fier. Lift up the casing and pull it horizontally away from the dehumidifier.
2 Remove the screws on the front of the lid that is placed on top of the com-
pressor (the control is placed in that box)
3 Push the lid against the back of the dehumidifier and pull it away from the
box. There is now access to the control.
Action
Action
Continued overleaf