Mirolin MIROGLIDE M33 Serie Instructions D'utilisation page 6

Note: Step 5A is for the following door
models only: M33, M34, M35, M38, M39,
5A 5A
M40, & M41.
Fasten to the wall with three #8 X 1-1/2"
(38 mm) screws through the three holes in the
Do not put screws through the adjusting blocks yet.
Repeat with the other plastic wall jamb.
T-8
#8 X 1-1/2" (38 mm)
SCREW
T-7
PLASTIC
JAMB
OUTSIDE
T-3
SILL
#8 x 1 1/2" (38 mm) SCREW
Guide each wall jamb (T-2) over the plastic
jamb and check for plumb with a level.
6 6
If adjustment is required, insert a Phillip's
screwdriver through the upper or lower hole,
turning the adjustment screw in or out until the
jamb is plumb.
When plumb, fasten each wall jamb to the wall using the
#8 X 3" (76 mm) screw through the hole.
CAUTION: Do not over tighten as it may distort the aluminum
jamb.
All manuals and user guides at all-guides.com
INSIDE TUB
6
Note: Step 5B is for the following door
models only: M36, M37, & 360.
5B 5B
Remove the plastic jamb.
Enlarge the holes in the wall by drilling with 1/4"
(6mm) drill bit.
Insert the wall anchors (T-16).
Reposition the plastic jamb and fasten to the wall with three #8 x
1-1/2 " (38mm) screws through the three holes in the jamb.
Do not put screws through the adjusting blocks yet.
Repeat with the other plastic wall jamb.
T-8
#8 X 1-1/2" (38 mm)
SCREW
T-7
PLASTIC
JAMB
OUTSIDE
T-3
SILL
#8 x 1 1/2" (38 mm) SCREW
T-2
WALL
JAMB
OUT
PLUMB
LEVEL
T-9
# 8 X 3 " (76 mm)
FLAT SCREW
OUTSIDE TUB
T-3
SILL
#8 X 3" (76 mm) SCREW
INSIDE TUB
T-7
PLASTIC
JAMB
INSIDE TUB