Publicité
Les langues disponibles
Les langues disponibles
Depending on the location of the shower head,
determine which way to position the
1 1
interchangeable panels (T-4, T-5, T-6), wall
jambs (T-2) and plastic jambs (T-7). See
Figures 1, 2, 3 or 4.
NOTE: Only for the M160/M360 and 360 Series door
installation: measure the wall opening at the tub rim and cut the
sill (T-3) to suit the full width of the tub.
Place the sill (T-3) on the rim of the tub/shower or shower stall,
in line and closer to the inner edge of the rim.
Draw a pencil line (A) along the outside and inside of the sill,
then remove the sill.
Apply a bead of silicone caulking(B) along the outside pencil
line. Press the sill onto the base in the original position using
the inside pencil line as a guide.
Remove excess silicone.
PENCIL
Carve out, with a knife the three fins on the
rear side of each plastic jamb in order that it
3 3
may fit the contour of the raised bands of the
acrylic tub/shower or shower stall.
(Not applicable to fiberglass products,
model #s: 314836AC, 374835A, 326032A,
376032B, M41 & 360 Series door
installation).
Slide the adjustment blocks (T-12) into each end of the plastic
jambs (T-7). Be sure that the adjustment screws are all the way
into the adjustment blocks.
Lay one plastic jamb (T-7) and an aluminum wall jamb (T-2)
side by side on a flat surface.
Align the adjusting blocks (T-12) with the prepunched holes in
the aluminum jamb. Mark the location of the adjusting blocks.
Repeat with the other plastic jamb and aluminum wall jamb.
PREPUNCHED HOLE
PENCIL MARK
T-2
WALL JAMB
PENCIL MARK
All manuals and user guides at all-guides.com
PENCIL
SILICONE
T-12
ADJUSTMENT
BLOCK
T-7 PLASTIC
JAMB
CARVE OUT
Position the plastic jambs against the wall
according to the position as shown ensuring
2 2
that the flexible fins are against the tub wall.
Plumb with level and pencil mark as shown.
(Note: Not applicable for M36, M37, M41 & 360 installation.
T-7
PLASTIC
JAMB
OUTSIDE
T-3
SILL
Reposition the plastic jamb and drill three 1/8"
(3 mm) holes through the plastic wall jamb and
4 4
shower wall. The holes should be spaced
along the jamb and drilled as perpendicular to
the wall as possible.
Check that the adjusting blocks are in the
marked position.
Drill a 1/8" (3 mm) hole through each adjusting block, the
plastic jamb and the shower wall.
Drill the holes as perpendicular as possible.
DRILL
DRILL
T-7
PLASTIC
JAMB
DRILL
DRILL
DRILL
OUTSIDE
T-3
SILL
5
RAISED
BANDS
LEVEL
INSIDE TUB
INSIDE TUB
Publicité
