Publicité
Les langues disponibles
Les langues disponibles
List of contents
1 x Planing / Sander
2 x Keys
1 x Removal tool
Spare sanding tubes
(dependant on kit)
1 x Blade setting gauge
1 x Ear plugs
Safety Warnings – Operating
Instructions
The Planer / Sander is designed to be used either as a
conventional hand held powered planer, or as a hand held
powered drum sander. These instructions give details on how
to set the tool for both functions.
As with all power tools this tool is powered by electricity, has
exposed rotating parts, makes noise and creates dust. To
ensure personal safety and the safety of others it is essential
that the user reads and fully understands these instructions
and then considers and assesses the dangers carefully before
use. If the user does not fully understand how to use the tool,
or does not feel confident, they should seek instruction from a
suitably trained professional before use.
WARNING ! Wait for the cutter to stop before setting
the tool down. An exposed cuttermay engage the surface
leading to possible loss of control and serious injury. Use the
workstand provided.
Setting the Sanding Cutting Depth
The sanding depth can be set to anywhere up to a maximum
indicated setting (approx. 0.5mm). When using the tool as a
sander it is not recommended to set the depth greater than the
maximum indication on the top of the sander depth scale. For
a high quality finish using less effort, make several shallow
passes. Use a lower cutting depth when working with harder
materials.
a)
Identify the sanding depth scale (See Illustrated
Description of Functions)
b)
Turn the depth adjuster knob fully anticlockwise until
the arrow lines up with indicator pointer
c)
Turn the knob clockwise until the required depth is
achieved
WARNING! In sanding mode the drum will always
remain slightly proud of the base plate even when the arrow
indicates a minimum setting.
1 x Fence guide
1 x Vacuum adapter
1 x Dust bag
1 x Instruction manual
1 x Case
2 x Spanners
1 x Dust mask
2
Changing Sanding tubes
Sanding tubes are supplied (depending on kit) with varying
grit finishes. These can be changed depending on the
amount of sanding to be carried out & level of surface finish
required. Tubes can be changed by following the
procedure.
a)
Unplug the tool from the electricity supply.
b)
Remove the end cap screws using the Torx key
provided
c)
Pull end cap away from side of machine to expose
the tube
d)
Using the small spanner to hold the shaft, place the C
spanner into the slots and release (Diagram A)
e)
Remove the locking nut and tube assembly
f)
Remove the drum end cap which should come away
from the assembly without resistance
g)
Remove the drive end cap by pushing it through the
middle of the sanding tube. This part is held in-situ by
a rubber grip ring (Diagram B)
h)
Replace with another tube and re-assemble
Precision Tools Ltd. 2010
Publicité
