Publicité
Les langues disponibles
Les langues disponibles
T able of Contents
1 0 B
1 0 B T able of Contents..........................................................2
1 1 B S afety Information.........................................................2
0 B W arranty.........................................................................3
1 B P re-Installation ..............................................................4
1 3 B P lanning For Successful Installation ..........................4
1 4 B I nstallation Options.....................................................4
1 5 B Tools Required ..........................................................5
Materials Required .....................................................5
1 6 B H ardware Included .....................................................5
S afety Information
1 1 B
1. This ventilation fan is approved for use over a
bathtub or shower when installed in a GFCI
protected circuit. Do not use unapproved fans
over a bathtub or shower that is not approved for
that application.
2. Installation work must be carried out by a
qualified person(s) in accordance with all local
and safety codes including the rules for fire-rated
construction.
3. Always vent fans to the exterior and in
compliance with local codes.
4. Install ductwork in a straight line with minimal
bends.
5. Use 120 V, 60 Hz for the electrical supply and
properly ground the unit. Follow all local safety
and electrical codes.
6. Do not use this fan with any solid-state control
device; such as a dimmer switch. Solid-state
controls may cause harmonic distortion, which
can cause a motor humming noise.
7. To reduce the risk of fire or electric shock, do not
block air entry grill.
8. Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
back drafting.
3 B 1 7 B P ackage Contents......................................................... 6
4 B I nstallation ..................................................................... 7
8 B T roubleshooting.......................................................... 11
9 B C are and Cleaning ...................................................... 12
1 2 B S pecifications.............................................................. 12
1 8 B D imensions .............................................................. 12
Service Parts ............................................................... 13
VFB25ACLED Serviceable Parts............................. 13
Follow the heating equipment manufacturer's guideline
and safety standards such as those published by the
National Fire Protection Association (NFPA), and the
American Society for Heating, Refrigeration and Air
conditioning Engineers (ASHRAE), and the local code
authorities.
WARNING Not suitable for use as a range hood or
in areas where hazardous or explosive vapors are
present.
CAUTION: Do not install in locations where the air
temperature will exceed 104°F (40°C).
IMPORTANT: Exercise care to not damage
existing wiring when cutting or drilling into walls or
ceilings.
NOTE: Make sure duct work size is a minimum of
the discharge. Do not reduce. Reducing the duct
size can increase fan noise.
IMPORTANT: You may want to consult with a
professional electrician regarding the wiring of your
ventilation fan.
WARNING: To reduce the risk of electric shock,
please disconnect the electrical supply circuit to the
fan before installing light kit.
CAUTION: This product must properly connect to
the grounding connector of the supply circuit.
2
Publicité
