Publicité
CUADRO
RONDA
1.- Prepare the wall for the internal
body installation as it shows on
the drawing A, B and C. Install the
internal body part with the attached
protection (if it has one) inside the
wall. Connect the supply lines (hot
to the left and cold to the right).
TEMPERATURE REGULATION
1. Open the water flow and mesaure
the temperature with a thermometer.
Whitout reasing the security button,
turn the handle until the water flow
reaches the temperature of 38ºC.
4
1.- If it is necessary take the
protection off of the body.
Bulled the external parts.
2. Take the temperature regulation
handle off.
INSTALLATION
Instalation range
Instalation range
1.- Place the wall plate (a) as per drawing.
2.- Place the trim nut (b) and tighten it until the
wall plate is properly fixed.
3.- Measure the distance between the piece
(b) and the external part of piece (c). If the
measure is equal or longer than 7mm, it has
to be removed the piece (d) to allow a longer
installation range.
3. Re-assemble
the
temperature
reguilation handle in such a way that
the safety pushbutton is aligned with
the red mark.
Publicité
