Grohe Grohtherm Wireless! 45 441 Mode D'emploi page 10

Settings
Enter SETUP mode and adjusting settings.
With the shower off (but with the Base Unit still connected to
mains electricity supply), press Pause and Override (+)
buttons simultaneously for approximately 5 seconds.
=>The word SETUP will be displayed.
Press the Override (+) button to scroll through the following
options:
The options will return to the top of the list after the last one
is reached.
Safety information
By changing pre-settings of START T, OVERRIDE or
MAXTEMP to values more than 43 °C danger of
scalding!
Display Function
START T
The Start button
in °C (20 °C to MAX-TEMP
in 0.5 degree steps)
OVRRIDE The temperature at which the
Override (+) must be pressed
before further increasing the
temperature (20 °C to
MAXTEMP in 0.5 degree steps)
MAXTEMP The maximum temperature that
the shower allows (30 °C
to 65 °C in 0.5 degree steps)
DEGREE To switch between Centigrade
and Fahrenheit
DECIMAL To switch between showing the
decimal or not
SYNCHRO To synchronise water
temperature - only for installers
(34 °C to 42 °C in 0.5 degree
steps)
ONFLOW
To change the Start button
flow rate (1 to 12)
FALLBAK To change the flow rate after
starting the water flow from the
Remote Controller (1 to 12)
MAXFLOW The maximum flow setting
(0 to 100)
MINFLOW The minimum flow setting
(0 to 99)
7
All manuals and user guides at all-guides.com
Default
38 °C
temperature
38 °C
43 °C
Centigrade
Decimal
38 °C
9
1
100
50
Display Function
ONDELAY A shower start delay for user
convenience when using Main
Controller only (0 to 3
in 0.5 second steps)
BACKLIT The time the display backlight
remains illuminated (0 to 30
in 1 second steps)
I TIME The automatic switch off time
when using the Main Controller
(0 to 30 in 1 minute steps)
P TIME The automatic switch off time
when using the Pause function
(0 to 30 in 1 minute steps)
R TIME The automatic switch off time
when starting from the Remote
Controller (0 to 30 in 1 minute
steps)
Change the above settings by turning the Temperature
Knob then press the Pause Button to confirm. Finally, exit
the SETUP menu by selecting EXIT (otherwise the change
will not be saved).
Display Function
REGISTR To register new controllers, siehe Seite 8
RESET To reset to factory default settings
VERSION To find out which software version is
installed
SERVICE To enter a service mode – only for service
engineers
EXIT To exit the SETUP menu
Press Pause to activate the above.
Note: The Main Controller will automatically exit the SETUP
menu if no adjustments are carried out over a 5 minute period.
No setting changes will be saved in this case.
Default
0.5 secs
10 secs
30 mins
5 mins
5 mins