Dell Latitude C/Dock II Expansion Station Guide D'information page 18

16 System Infor mation Guide
Docking for the First Time With Windows 95
Dock and turn on your computer.
1
Either press <F2> during the system boot routine, or press
2
<Fn><F1> after your computer boots to view the system setup
program.
Set Docking IRQ to Optimized.
3
Set Universal Connect to Enabled.
4
Exit the system setup program.
5
The computer automatically detects new hardware.
Click Yes at the System Settings Change window.
6
The computer restarts and automatically detects new hardware.
If the Configuration Setup window appears, click OK.
7
Click OK at the Network window.
8
Select the Identification tab at the next Network window.
9
Enter a Computer Name and Workgroup that will identify your
10
computer on the network, and click Close.
If you are unsure what Computer Name and Workgroup to enter,
check with your system administrator.
NOTE: You must enter a Computer Name and Workgroup to proceed with the
driver installation.
The computer automatically copies files and builds a driver
information database.
Click Yes at the System Settings Change window.
11
The computer restarts.
An Enter Network Password window appears. If you do not wish to set
a username and password at this point, or if you have not yet been
provided one for use by your system administrator, click Cancel.
The computer automatically detects new hardware.
Click OK at the Configuration Setup window.
12
The Windows desktop appears and the installation is complete.