Oursson COLOR COFFEE AM6250 Manuel D'instructions page 34

All manuals and user guides at all-guides.com
3. Install brew unit back to the coffee machine till it goes
click (do not push the lever), Pic. G-5.
4. Install back residue container and close the door.
NOTE: Clean the brew unit once per week.
Milk frother cleaning, Pic. G-6
• Ensure that the unit is disconnected from
electricity network prior assembling or
dissembling procedures.
1. Disconnect milk frother unit by slightly pressing from
the both sides, Fig. G-6-1.
2. Dissemble the milk frother according to the scheme.
Wash him with the warm flow water, G-6-3.
3. Clean the both holes with brush, Fig. G-6-2.
4. Assemble the milk frother and install it to the unit, Fig.
G-6-4
NOTE: Clean the milk frother once per week.
cleaning of the pouring holes, Pic. G-7
Clean the pouring holes with a wet soft cloth on a daily
basis. Ensure that holes have no scurf, Pic. G-11.
To clean the holes, select
then cleaning and select
flushing, main menu will appear at the display.
cleaning of brew unit with tablets, Pic. G-8
After a long-term usage of coffee machine, particles of
coffee powder and oils a in the brew unit, perform the
cleaning procedures.
• Use only special tablets intended for brew
unit cleaning. Ensure that tablets are suitable
for your type of coffee machine.
• Do not interrupt the cleaning process, it can
cause damage to the machine. Wait until the
cleaning process is complete.
Be careful, protect your eyes and skin from
contact with cleaning substance. In the
event of contact – immediately flush them
with clean water.
1. Select Menu at the main display, then select
cleaning and choose
2. Put an empty container under the pouring holes.
Select , to start cleaning of the brew unit, Pic.
G-8-4.
3. When the relevant image will appear at the display,
open coffee beans container, remove grind coffee lid
and add a tablet, Pic. G-8-6, close the both containers
and press , Pic.G-8-7.
4. Coffee machine will return to standby mode after
completion of cleaning.
NOTE: Clean the brew unit once per month.
Scale removal, Pic. G-9
Everyday exploitation of coffee machine leads to scale
formation inside the machine. Scale volume depends on
water hardness.
• Use only special agents for scale removal.
1. Press menu at the main display, then
and press scale removal.
2. Fill container with clean water, add the required amount
of special agents according to the manual. Total amount
of liquid shall be at MAX level, Pic. G-9-5.
34
menu at the main display,
flushing, Pic. G-7. After
brew unit, Pic.G-8-1...G-8-3.
cleaning
3. Put a big empty container under the pouring holes,
press , to start cleaning, Pic. G-9-6. The cycle ends
when the water container is empty.
4. Follow instructions at the display. Fill water container
with clean water, Pic. G-9-8. Press
cleaning cycle.
5. Coffee machine will return to standby mode after
completion of cleaning.
NOTE: We recommend to remove scale once per month.
• It is prohibited to drink the substance, which
comes out during the cleaning process.
cleaning of milk frother, Pic. G-10.
After a long-term exploitation of coffee machine, milk frother
shall be cleaned.
1. Press menu at the main display, then
and choose milk frother, Pic.G-10-3.
2. Connect milk feeding pipe to the milk frother hole, install
the other end of pipe to the hole at tray grating, Pic.
G-10-4.
3. Follow the instructions at the display. Press
start cleaning procedures.
4. Coffee machine will return to standby mode after
completion of cleaning. Discharge water from the tray.
, to start the
cleaning
, to