Oursson COLOR COFFEE AM6250 Manuel D'instructions page 33

All manuals and user guides at all-guides.com
of coffee beans , time (volume) of hot milk froth
, pump pressure . In order to change these
paramters, press them as many times as necessary
until you see the result, Pic. F-3
Parameters that can be configured depending on the
type of coffee drink:
Drink volume . Available variations: 20 ml, 25 ml, ...
250 ml.
Temperature . Available variations: 75°С, 80°С ... 95°С.
Amount of coffee beans . Available variations: 7g, 8g
... 12g.
Time (volume) of hot milk froth
15s, 20s ... 60s.
Pump pressure . Available variations: high pressure, low
pressure.
Volume of hot water . Available variations: 0 ml, 10ml ...
200 ml.
4. Press two times to save the parameters and exit
to the main menu.
Coffee machine settings, Pic. F-4 – F-8.
1. Press menu at the main display to change the
parameters of the coffee machine.
2. Select timer to set up the timer value. Available
variations: Switch off 0.5h, 1h, ... 24 h, Pic. F-4.
3. Select sound to switch on/off sound for display
tapping, Pic. F-5.
4. Select hardness of water to choose descaling
cycles depending on water type, Pic. F-6
Available options:
soft – descaling required after each 880 cups of
coffee;
average - descaling required after each 400 cups
of coffee;
hard - descaling required after each 280 cups of
coffee;
very hard - descaling required after each 240
cups of coffee.
If water is harder than installed by default options, so it
may affect the taste of coffee drinks, as well as lead to
damage of coffee machine.
5. Press display to configure the display brightness,
Pic. F-7.
6. Press language the required amount of times to
select the menu language, Pic. D-16.
Available options: English, French, German,
Russian.
7. Press counter to see the statistics of the coffee
machine, Pic. F-8.
8. Calibration is intended for using by authorized
specialists of OURSSON Trademark only, Pic. F-9.
9. Press two times to save the parameters and exit
to the main menu.
Switching off the coffee machine, Pic. F-10.
1. At the end of exploitation of coffee machine, put an
empty cup under the pouring holes. After a configured
time period, coffee machine will flush the pouring holes
and switch to standby mode.
2. You can switch off the machine in manual mode by
pressing switch on/off button during 2-3 sec at the front
panel, Pic. F-10.
3. For complete switch off the machine, press the tumbler
on the backside, Pic. D-9. After that, disconnect the unit
from the electrical network.
cLEANING AND MAINTENANcE, Pic. H
•
•
. Available variations:
•
•
•
•
•
Daily cleaning of milk supply pipe, Pic. G-1
1. Connect milk-feeding pipe to the milk frother hole.
2. Put the other end of the pipe to a container with clean
3. Put an empty cup under the pouring holes and press
4. Empty the cup after completion of cleaning. Repeat the
cleaning of tray for liquids, Pic. G-2
1. When indicator tray filling pops up, remove the tray,
2. Carefully dry all components and install them to their
NOTE: Clean the tray once per week.
cleaning of residue container, Pic. G-3
Residue container volume is designed for 10 cups.
1. The relevant indication will appear at the display if the
2. Open the right door, remove residue container, clean it,
Infuser cleaning, Pic. G-4
1. Open the right door and remove residue container, Pic.
2. Carefully wash brew unit with warm water. Dry it (do
• clean the machine components on a
regular basis after the each use. cleaning is
required for stable work of the machine.
Disconnect the machine from electrical network and
allow it to cool completely.
Clean the case with a wet cloth. Use only dry and
soft cloth to clean the control panel.
• Never put the machine into water due to
electric shock danger.
Tray for liquid, water container, measuring spoon
and residue container can be washed in dish
washing machine. The temperature in dish washing
machine shall not exceed 60°С.
Milk supply pipe, cleaning brush, tray lid are washed
in warm water with washing-up liquids, Рис.H.
Use a brush to clean hard-to-get places of coffee
machine from grind coffee.
Clean the bean container with a dry sponge or paper.
Carefully dry all machine components after cleaning.
Be careful while cleaning in order not to burn
fingers with steam blast or hot water.
• clean the milk supply pipe at the end of a day
if the milk was used. Follow the instructions
bellow to avoid burns.
water.
milk button at the menu.
aforementioned steps for complete cleaning of pipe
from old milk.
remove the grating and wash them with warm water
and washing-up liquid.
positions.
container is full.
and install back.
• Ensure that the unit is disconnected from
electricity network prior assembling or
dissembling procedures.
G-3. Then push the lever on the brew unit, pull on the brew
unit and remove it from the coffee machine, Pic. G-4.
not clean the brew unit with a shaggy cloth to avoid
clogging).
33