Publicité
Les langues disponibles
Les langues disponibles
Signal Booster Specifications
Model Number
FCC Number
IC Number
Connectors
Antenna Impedance
Frequency
Passband Gain (nominal)
20 dB Bandwidth (MHz)
Power output for single cell phone (dBm)
Power output for multiple received channels
(Uplink) dBm
Power output for multiple received channels
(Downlink) dBm
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the
rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This
power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage
of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal
is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band.
For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such automatic
restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing power from
the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
The term "IC" before the radio certification number only signifies that Industry Canada technical specifications were met.
Need help?
Typical
Maximum
Uplink
Downlink
No. Tones
2
3
4
5
6
No. Tones
2
3
4
5
6
www.wilsonelectronics.com
Dual-Band 800/1900 MHz Specifications
460009
PWO460009
4726A-460009
SMA-Female
50 Ohms
824-894 MHz & 1850-1995 MHz
800 MHz
13.4
800 MHz
41.7
43.3
800 MHz
23.8
-6.05
800 MHz
24.1
20.5
18.0
16.1
14.5
800 MHz
-3.2
-6.7
-9.2
-11.1
-12.7
4 dB (nominal)
> 60 dB
5V DC, 1A
Tech Support 866-294-1660
1900 MHz
12.3
1900 MHz
84.1
88.9
1900 MHz
22.3
-6.3
1900 MHz
23.2
19.6
17.1
15.2
13.6
1900 MHz
-4.7
-8.2
-10.7
-12.7
-14.2
7
Publicité
