Partyspace VEGA Mode D'emploi page 10

18 VEGA - MANUAL
DETERMINE THE ANCHORING POINTS
1. Determine the centre of the star tent. Place one of the rings of the measuring rope where
the centre of the star tent is to be located and anchor this point temporarily with a peg.
2. Form a triangle with the measuring rope and determine where the f irst 2 ground anchors
of the tent should be.
3. Ensure that the measuring rope is tight and is not doubled over anywhere in order to
correctly determine the anchoring points.
4. Place a peg through the two other rings of the measuring rope and into the ground up to
around 5 cm f rom the soil. These are the f irst two anchoring points.
1.
3.
2.
4.
EN EN
5. Take one ring f rom around a peg, so that only one side of the triangle remains intact.
6. Move the measuring rope to the remaining intact side and re-tighten it. Take care to ensure
that you use the same tension when determining all the anchoring points.
5.
6.
7. Repeat this process until all 6 anchoring points
have been established and are held in place by a
peg. Finally, replace the peg in the centre with the
pole base for soft ground.
19 VEGA - MANUAL