Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
to prevent detergent from sliding down and
streaking.
6. Allow detergent to remain on the surface
for a few minutes. This is a good time to use
a brush to lightly scrub heavily soiled areas.
Never allow detergent to dry on the
cleaning surface.
7. Remove detergent applicator from gun
and replace with the lance, or remove
applicator from end of lance.
8. Rinse detergent from surface.
NOTE:
Flush detergent applicator with
clear water following each use.
4. Final Rinse
start final rinse at bottom an work upward.
Make sure you thoroughly rinse the surface
and that all detergent has been removed.
5. Shut down
1. Be sure all detergent is flushed from
system.
2. Turn off motor.
3. Turn off water supply.
4. After motor and water supply are turned
off, trigger gun to depressurize system.
CAUTION:
NEVER turn water supply off
before turning motor off. Serious damage
could occur to the pump and or motor.
WARNING!
NEVER disconnect high
pressure discharge hose from machine
while system is pressurized. To
depressurize, turn motor off, turn water
supply off and squeeze gun trigger 2-3
times.
5. After each use, wipe all surfaces of the
pressure washer with a clean, damp cloth.
6. Storage
Do not store pressure washer outdoors.
Do not store pressure washer where it
might freeze.
TIPS FOR EXTENDING THE LIFE
OF YOUR PRESSURE WASHER
1. Never operate unit without water.
2. Pressure washer is not meant to pump
hot water. Never connect to hot water
supply – this will significantly reduce life of
the pump.
3. Using detergent other than others brand
may cause damage to pump components
(o-rings, etc.).This also applies to chemicals
such as bleach, dish soap, etc.
4. Never operate unit for more than one (1)
minute without spraying water. Resulting
13
Publicité
